Waterway Executive Pump Face-plate 2.5" 311-1210

Waterway Executive hot tub pump series wet end faceplate with 2-1/2" suction inlet.

Details:

• Waterway part #311-1210
• Made in the USA by Waterway Plastics
• Actual measurement of the intake is approximately 3-5/8" O.D,
• Faceplate does not include drain plugs, barb fittings, or o-rings.
• Drain plugs with o-rings are sold separately if required.
• Some pumps may have a small hose instead of one of the drain plugs which would require an additional barb fitting

Important.

• Fits Waterway Executive series pump models with first 7 digits of serial numbers starting from PF10277... and up, will not fit pumps with lower serial numbers. Pumps with lower serial numbers would need a complete replacement wet end as these parts may not fit. Will not fit any Waterway EX2 series pumps or any other spa pump brands.
• Waterway changed the design of this faceplate in late 2017. The part number remains the same however the new design requires TWO large o-rings instead of the old design which only used one. The faceplate o-rings are not included, part #805-0261 is sold separately and this faceplate requires a total of TWO.